Data Restore - DigiTech DigiGate-700 User Manual

Table of Contents

Advertisement

5 - 6
Figure 5-7
You must close the DigiGate-700™ for Windows® program before you restore your data.
The DigiGate-700™ for Windows® program opens certain files while it is operating. These files
cannot be properly restored to the system's hard disk until they are closed. If you receive any error
messages during a restore process, close the restore operation, make certain the DigiGate-700™
for Windows® program is closed, re-boot the computer if necessary and then restart the restore
procedure.
If you back up your files using another software package supplied with your backup device or a
third party software package, use that same software to restore the data to your system.
The following procedure applies to data that used the DigiGate-700™ for Windows® program
and the procedures outlined in this Chapter as the means of backup.
1.
From the System Toolbar , click on the
Utilities button. Figure 5-7

Data Restore

2.
This opens the Utility window. Figure 5-8
3.
Click on the Data Utilities tab.
Backing Up Your Data
Figure 5-8
DigiGate-700
for Windows
®

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DigiGate-700 and is the answer not in the manual?

Table of Contents

Save PDF