DigiTech DigiGate-700 User Manual page 24

1 - 10
Figure 1-20
8. Figure 1-20 shows the prompt you should see in
the Command Line text box. If this is not
what you see, type "A:\SETUP.EXE." If you
are installing from a CD ROM use the letter of
the CD ROM drive in place of the "A." Do
NOT type the quotation marks.
9. Click on the Finish button.
10. Note the Back button. Clicking on this button,
at any time it is active, will return you to the
previous step in the installation procedure
where you can edit the entry.
Figure 1-21
11. Figure 1-21 shows the Setup window which
loads the installation Wizard in Windows 95.
Wait this one out.
DigiGate-700
Introduction
for Windows
™ ®