Port Security Commands; Port-Security; Port-Security Max-Dynamic - D-Link DWL-8500AP Command Reference Manual

Interfaces

Port Security Commands

This section describes the command you use to configure Port Security on the switch. Port
security, which is also known as port MAC locking, allows you to secure the network by
locking allowable MAC addresses on a given port. Packets with a matching source MAC
address are forwarded normally, and all other packets are discarded.
To enable the SNMP trap specific to port security, see
NOTE:
traps violation"

port-security

This command enables port locking at the system level (Global Config) or port level (Interface
Config)
Default
Format
Modes
no port-security
This command disables port locking for one (Interface Config) or all (Global Config) ports.
Format
Modes

port-security max-dynamic

This command sets the maximum number of dynamically locked MAC addresses allowed on a
specific port.
Default
Format
Mode
no port-security max-dynamic
This command resets the maximum number of dynamically locked MAC addresses allowed
on a specific port to its default value.
Format
Mode
The list of interfaces that are designated for forwarding (Fwd:) and filtering
(Flt:).
on page 312.
disabled
port-security
Global Config
Interface Config
no port-security
Global Config
Interface Config
600
port-security max-dynamic <maxvalue>
Interface Config
no port-security max-dynamic
Interface Config
2 Switching Commands
"snmp-server enable
Port Security Commands 103