D-Link DWL-8500AP Command Reference Manual page 80

CLI Command Reference
If you use the optional parameter
the specified port or all ports are displayed.
Port
Control Mode The configured control mode for this port. Possible values are force-unauthor-
Operating Control Mode The control mode under which this port is operating. Possible val-
Reauthentication Enabled Indicates whether re-authentication is enabled on this port.
Key Transmission Enabled Indicates if the key is transmitted to the supplicant for the speci-
If the optional parameter 'detail
specified port are displayed.
Port
Protocol Version The protocol version associated with this port. The only possible value is 1,
PAE Capabilities The port access entity (PAE) functionality of this port. Possible values are
Authenticator PAE State Current state of the authenticator PAE state machine. Possible val-
Backend Authentication State Current state of the backend authentication state machine.
Quiet Period
Transmit Period The timer used by the authenticator state machine on the specified port to
Guest VLAN ID The ID of the VLAN used for unauthenticated or authentication failed
Guest VLAN Period The value, in seconds, of the timer used by the Guest VLAN Authenti-
Supplicant Timeout The timer used by the authenticator state machine on this port to time-
80 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
summary {<slot/port> | all}
The interface whose configuration is displayed.
ized | force-authorized | auto.
ues are authorized | unauthorized.
fied port.
<slot/port
The interface whose configuration is displayed.
corresponding to the first version of the dot1x specification.
Authenticator or Supplicant.
ues are Initialize, Disconnected, Connecting, Authenticating, Authenticated,
Aborting, Held, ForceAuthorized, and ForceUnauthorized.
Possible values are Request, Response, Success, Fail, Timeout, Idle, and Ini-
tialize.
The timer used by the authenticator state machine on this port to define peri-
ods of time in which it will not attempt to acquire a supplicant. The value is
expressed in seconds and will be in the range 0 and 65535.
determine when to send an EAPOL EAP Request/Identity frame to the suppli-
cant. The value is expressed in seconds and will be in the range of 1 and
65535.
users.
cation. The guest VLAN timeout must be a value in the range of 1 and 300.
The default value is 90. The guest VLAN becomes operational after this time-
out is reached giving enough time to the user to get authenticated.
out the supplicant. The value is expressed in seconds and will be in the range
of 1 and 65535.
, the dot1x configuration for
>' is used, the detailed dot1x configuration for the