Snmptrap Ipaddr; Snmptrap Mode; Snmp Trap Link-Status; Snmp Trap Link-Status All - D-Link DWL-8500AP Command Reference Manual

snmptrap ipaddr

This command assigns an IP address to a specified community name. The maximum length of
name is 16 case-sensitive alphanumeric characters.
IP addresses in the SNMP trap receiver table must be unique. If you make
NOTE:
multiple entries using the same IP address, the first entry is retained and pro-
cessed. All duplicate entries are ignored.
Format
Mode

snmptrap mode

This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able
to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format
Mode
no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are unable to receive traps.
Format
Mode

snmp trap link-status

This command enables link status traps by interface.
This command is valid only when the Link Up/Down Flag is enabled. See
NOTE:
"snmp-server enable traps linkmode"
Format
Mode
no snmp trap link-status
This command disables link status traps by interface.
This command is valid only when the Link Up/Down Flag is enabled.
NOTE:
Format
Mode

snmp trap link-status all

This command enables link status traps for all interfaces.
This command is valid only when the Link Up/Down Flag is enabled. See
NOTE:
"snmp-server enable traps linkmode"
snmptrap ipaddr <name> <ipaddrold> <ipaddrnew>
Global Config
snmptrap mode <name> <ipaddr>
Global Config
no snmptrap mode <name> <ipaddr>
Global Config
snmp trap link-status
Interface Config
no snmp trap link-status
Interface Config
7 Management Commands
on page 313.
on page 313.
SNMP Commands 315