Show Arp Brief; Show Arp Switch; Ip Routing Commands - D-Link DWL-8500AP Command Reference Manual

The following are displayed for each ARP entry.
IP Address
MAC Address The hardware MAC address of that device.
Interface
Type
Age

show arp brief

This command displays the brief Address Resolution Protocol (ARP) table information.
Format
Mode
Age Time (seconds) The time it takes for an ARP entry to age out. This value is configurable.
Response Time (seconds) The time it takes for an ARP request timeout. This value is config-
Retries
Cache Size
Dynamic Renew Mode Displays whether the ARP component automatically attempts to
Total Entry Count Current / Peak The total entries in the ARP table and the peak entry
Static Entry Count Current / Max The static entry count in the ARP table and maximum

show arp switch

This command displays the contents of the switch's Address Resolution Protocol (ARP) table.
Format
Mode
IP Address
MAC Address The hardware MAC address of that device.
Interface

IP Routing Commands

This section describes the commands you use to enable and configure IP routing on the switch.
The IP address of a device on a subnet attached to an existing routing inter-
face.
The routing slot/port associated with the device ARP entry.
The type that is configurable. The possible values are Local, Gateway,
Dynamic and Static.
The current age of the ARP entry since last refresh (in hh:mm:ss format
show arp brief
Privileged EXEC
Age time is measured in seconds.
urable. Response time is measured in seconds.
The maximum number of times an ARP request is retried. This value is con-
figurable.
The maximum number of entries in the ARP table. This value is configurable.
renew dynamic ARP entries when they age out.
count in the ARP table.
static entry count in the ARP table.
show arp switch
Privileged EXEC
The IP address of a device on a subnet attached to the switch.
The routing slot/port associated with the device's ARP entry.
3 Routing Commands
IP Routing Commands 121