Rf Scan Access Point Status Commands; Clear Wireless Ap Rf-Scan List; Show Wireless Ap Rf-Scan Status - D-Link DWL-8500AP Command Reference Manual

Dws-3000 series/ unified wired & wireless access system
Hide thumbs Also See for DWL-8500AP:
Table of Contents

Advertisement

CLI Command Reference
MAC Address The Ethernet address of the AP.
IP Address
Last Failure Type Indicates the last type of failure that occurred.
Validation Failure Count The count of association failures for this AP.
Authentication Failure Count The count of authentication failures for this AP.
Vendor ID
Protocol Version Indicates the protocol version supported by the software on the AP.
Software Version Indicates the version of software on the AP.
Hardware Type Hardware platform for the AP.
Age

RF Scan Access Point Status Commands

The commands in this section provide views and management of data maintained for all
access points known by the Unified Switch via RF scan data obtained from the managed
access points.

clear wireless ap rf-scan list

This command deletes all entries from the RF scan list; entries normally age out according to
the configured age time.
Format
Mode

show wireless ap rf-scan status

This command displays summary or detailed data for APs detected via RF scan on the
managed APs. If the optional MAC address parameter is specified, detailed data is displayed.
Format
Mode
macaddr
MAC Address The Ethernet MAC address of the detected AP, this could be a physical radio
SSID
Physical Mode Indicates the 802.11 mode being used on the AP.
Channel
Transmit Rate Indicates the rate at which the AP is currently transmitting data.
Beacon Period Beacon interval for the neighbor AP network.
198
© 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
The network IP address of the AP.
Vendor of the AP software.
Time in seconds since failure occurred.
clear wireless ap rf-scan list
Privileged EXEC
show wireless ap [<macaddr>] rf-scan status
Privileged EXEC
AP MAC address detected in RF scan.
interface or VAP MAC. For D-Link APs, this is always a VAP MAC address.
Service Set ID of the network, this is broadcast in detected beacon frame.
Transmit channel of the AP.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dwl-3500ap

Table of Contents