Access Point Profile RF Commands
The commands in this section provide RF configuration per radio interface within an access
point profile.
radio
This command enters the AP profile radio configuration mode. In this mode you can modify
the radio configuration parameters for an AP profile.
Format
Mode
1-2
enable (AP Profile Radio Config Mode)
This command configures the administrative mode of the radio interface to the "on" state.
Default
Format
Mode
no enable
The
version of this command configures the administrative mode of the radio interface to
no
the "off" state.
Format
Mode
rf-scan other-channels
This command enables the radio to perform RF scanning on channels other than its operating
channel. The optional interval parameter indicates how often the radio leaves it operational
channel.
Default
Format
Mode
interval
30-120
radio <1-2>
AP Profile Config
The radio interface within the AP profile.
on
enable
AP Profile Radio Config
no enable
AP Profile Radio Config
Enabled
interval, 60 seconds
rf-scan other-channels [interval <30-120>]
AP Profile Radio Config
Interval at which the AP will move away from its operating channel
Time interval in seconds
4 Wireless Commands
Access Point Profile RF Commands
173