Wmm; Load-Balance - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference
no rate
The version of this command is used to remove an advertised or supported data rate from
no
the corresponding list.
Format
Mode
value

wmm

This command enables WMM mode for the radio. WMM mode is Wi-Fi Multimedia mode.
When enabled QoS settings affect both downstream traffic to the station (AP EDCA
parameters) and upstream traffic to the AP (station EDCA parameters). When disabled QoS
only applies to downstream traffic.
Default
Format
Mode
no wmm
The version of this command disables WMM mode for the radio.
no
Format
Mode

load-balance

This command enables load balancing. The optional utilization parameter indicates the
percentage of network utilization allowed on the radio before clients are denied. 0% indicates
that no load balancing is performed.
Default
Format
Mode
1-100
no load-balance
The version of this command disables load balancing or resets the utilization to its default
no
value. If no parameters are entered, load balancing is disabled.
Format
Mode
180 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
no rate {advertised | supported} <value>
AP Profile Radio Config
A valid rate based on radio mode.
Enabled
wmm
AP Profile Radio Config
no wmm
AP Profile Radio Config
Disabled
utilization, 60%
load-balance [utilization <1-100>]
AP Profile Radio Config
Percentage of network utilization allowed on the radio
no load-balance [utilization]
AP Profile Radio Config