Routing; Ip Routing; Ip Address - D-Link DWL-8500AP Command Reference Manual

CLI Command Reference

routing

This command enables IPv4 routing for an interface. You can view the current value for this
function with the
Default
Format
Mode
no routing
This command disables routing for an interface.
You can view the current value for this function with the
is labeled as "Routing Mode."
Format
Mode

ip routing

This command enables the IP Router Admin Mode for the master switch.
Format
Mode
no ip routing
This command disables the IP Router Admin Mode for the master switch.
Format
Mode

ip address

This command configures an IP address on an interface. You can also use this command to
configure one or more secondary IP addresses on the interface.The value for
IP address of the interface. The value for
which represents the subnet mask of the interface. The subnet mask must have contiguous
ones and be no longer than 30 bits, for example 255.255.255.0. This command adds the label
IP address in
Format.
Mode
no ip address
This command deletes an IP address from an interface. The value for
address of the interface. The value for
which represents the Subnet Mask of the interface.
Format
122 © 2001- 2008 D-Link Corporation/D-Link Systems, Inc. All Rights Reserved.
command. The value is labeled as "Routing Mode."
show ip brief
disabled
routing
Interface Config
no routing
Interface Config
ip routing
Global Config
no ip routing
Global Config
.
show ip interface
ip address <ipaddr> <subnetmask> [secondary]
Interface Config
no ip address <ipaddr> <subnetmask> [secondary]
show ip brief
is a 4-digit dotted-decimal number
<subnetmask>
is a 4-digit dotted-decimal number
<subnetmask>
command. The value
is the
<ipaddr>
is the IP
<ipaddr>