Station-Isolation; Super-A; Super-G - D-Link DWL-8500AP Command Reference Manual

station-isolation

Use this command to enable Station Isolation. When Station Isolation is enabled, the AP
blocks communication between wireless stations. The AP still allows data traffic between its
wireless clients and wired devices on the network, but not among wireless clients. The Station
Isolation setting is part of the configuration profile that the switch sends to the Managed AP.
Default
Format
Mode
no station-isolation
Use this command to disable Station Isolation.
Format
Mode

super-a

This command enables the Super A mode on the radio. Super A mode enables Atheros frame
compression and fast-frames mode. In order to use channel aggregation, the radio must be set
to Atheros Dynamic Turbo mode.
Default
Format
Mode
no super-a
The version of this command disables the Super A mode on the radio.
no
Format
Mode

super-g

This command enables the Super G mode on the radio. Super G mode enables Atheros frame
compression and fast-frames mode. In order to use channel aggregation, the radio must be set
to Atheros Dynamic Turbo modes.
Default
Format
Mode
no super-g
The version of this command disables the Super G mode on the radio.
no
Format
Mode
disabled
station-isolation
AP Profile Radio Config
station-isolation
AP Profile Radio Config
Disabled
super-a
AP Profile Radio Config
no super-a
AP Profile Radio Config
Disabled
super-g
AP Profile Radio Config
no super-g
AP Profile Radio Config
4 Wireless Commands
Access Point Profile RF Commands 175