System Information And Statistics Commands; Show Arp Switch; Show Eventlog; Show Hardware - D-Link DWL-8500AP Command Reference Manual

System Information and Statistics Commands

This section describes the commands you use to view information about system features,
components, and configurations.

show arp switch

This command displays the contents of the IP stack's Address Resolution Protocol (ARP)
table. The IP stack only learns ARP entries associated with the management interfaces -
network or service ports. ARP entries associated with routing interfaces are not listed.
Format
Mode
IP Address
MAC Address Hardware MAC address of that device.
Interface

show eventlog

This command displays the event log, which contains error messages from the system. The
event log is not cleared on a system reset.
Format
Mode
File
Line
Task Id
Code
Time
Event log information is retained across a switch reset.
NOTE:

show hardware

This command displays inventory information for the switch.
The
NOTE:
show version
same information. In future releases of the software, the
mand will not be available. For a description of the command output, see the
"show version" command.
Format
Mode
show arp switch
Privileged EXEC
IP address of the management interface or another device on the management
network.
For a service port the output is
the slot/port of the physical interface.
show eventlog
Privileged EXEC
The file in which the event originated.
The line number of the event
The task ID of the event.
The event code.
The time this event occurred.
command and the
show hardware
Privileged EXEC
. For a network port, the output is
Management
command display the
show hardware
show hardware
System Information and Statistics Commands
6 Utility Commands
com-
257