Routing Commands; Address Resolution Protocol (Arp) Commands; Arp - D-Link DWL-8500AP Command Reference Manual

Routing Commands

This chapter describes the routing commands available in the D-Link Unified Wired/Wireless
Access System CLI.
The Routing Commands chapter contains the following sections:
•

"Address Resolution Protocol (ARP) Commands"

• "IP Routing Commands"
• "Virtual LAN Routing Commands"
• "Virtual LAN Routing Commands"
• "Virtual Router Redundancy Protocol Commands"
• "DHCP and BOOTP Relay Commands"
The commands in this chapter are in one of three functional groups:
• Show commands are used to display switch settings, statistics and other information.
• Configuration Commands are used to configure features and options of the switch. For
every configuration command there is a show command that will display the configuration
setting.
• Clear commands clear some or all of the settings to factory defaults.
Address Resolution Protocol (ARP) Commands
This section describes the commands you use to configure ARP and to view ARP information
on the switch. ARP associates IP addresses with MAC addresses and stores the information as
ARP entries in the ARP cache.

arp

This command creates an ARP entry. The value for
on a subnet attached to an existing routing interface.
that device.
The format of the MAC address is 6 two-digit hexadecimal numbers that are separated by
colons, for example 00:06:29:32:81:40.
Format
Mode
on page 121
arp <ipaddress> <macaddr>
Global Config
on page 117
on page 129
on page 129
on page 130
on page 135
<ipaddress>
<macaddr>
Address Resolution Protocol (ARP) Commands
3
is the IP address of a device
is a unicast MAC address for
117