Quality Of Service (Qos) Commands; Class Of Service (Cos) Commands; Classofservice Dot1P-Mapping - D-Link DWL-8500AP Command Reference Manual

Quality of Service (QoS) Commands

This chapter describes the Quality of Service (QoS) commands available in the D-Link
Unified Wired/Wireless Access System CLI.
The QoS Commands chapter contains the following sections:
•

"Class of Service (CoS) Commands"

• "Differentiated Services (DiffServ) Commands"
• "DiffServ Class Commands"
• "DiffServ Policy Commands"
• "DiffServ Service Commands"
• "DiffServ Show Commands"
• "MAC Access Control List (ACL) Commands"
• "IP Access Control List (ACL) Commands"
The commands in this chapter are in one of two functional groups:
• Configuration Commands are used to configure features and options of the switch. For
every configuration command there is a show command that will display the configuration
setting.
• Show commands are used to display device settings, statistics and other information.
Class of Service (CoS) Commands
This section describes the commands you use to configure and view Class of Service (CoS)
settings for the switch. The commands in this section allow you to control the priority and
transmission rate of traffic.
NOTE:

classofservice dot1p-mapping

This command maps an 802.1p priority to an internal traffic class. The
values can range from 0-7. The
number of available traffic classes depends on the platform. For more information about
802.1p priority, see
Commands you issue in the Interface Config mode only affect a single inter-
face. Commands you issue in the Global Config mode affect all interfaces.
"Provisioning (IEEE 802.1p) Commands"
on page 227
on page 232
on page 233
on page 237
on page 241
on page 242
on page 246
on page 249
values range from 0-6, although the actual
<trafficclass>
<userpriority>
on page 64.
Class of Service (CoS) Commands
5
227