Routing/Ipv6 Routing - D-Link 5000 Series Cli Reference Manual

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
Component
DiffServ

Routing/IPv6 Routing

Table 48: DHCP Relay Log Messages
Component
DHCP relay
DHCP relay
DHCP relay
Table 49: OSPFv2 Log Messages
Component
OSPFv2
OSPFv2
Message
Policy invalid for service intf: policy
name, interface x, direction y
Message
Request hops field more than
config value
Request's seconds field less than
the config value
processDhcpPacket: invalid DHCP
packet type: %u\n
Message
Best route client deregistration
failed for OSPF Redist
XX_Call() failure in _checkTimers
for thread 0x869bcc0
1240
Cause
The DiffServ policy definition is not
compatible with the capabilities of the
interface specified. Check the platform
release notes for information on
configuration limitations.
Cause
The DHCP relay agent has processed a
DHCP request whose HOPS field is larger
than the maximum value allowed. The relay
agent will not forward a message with a
hop count greater than 4.
The DHCP relay agent has processed a
DHCP request whose SECS field is larger
than the configured minimum wait time
allowed.
The DHCP relay agent has processed an
invalid DHCP packet. Such packets are
discarded by the relay agent.
Cause
OSPFv2 registers with the lPv4 routing
table manager ("RTO") to be notified of
best route changes. There are cases where
OSPFv2 deregisters more than once,
causing the second deregistration to fail.
The failure is harmless.
An OSPFv2 timer has fired but the
message queue that holds the event has
filled up. This is normally a fatal error.