Port Security Commands - D-Link DGS-3212SR Command Line Interface Reference Manual

12-port gigabit layer 2 stackable switch
Hide thumbs Also See for DGS-3212SR:
Table of Contents

Advertisement

The switch port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config port_security ports
show port_security
delete port_security_entry
vlan_name
clear port_security_entry port
Each command is listed, in detail, in the following sections.
config port_security ports
Purpose
Syntax
Description
Parameters
DGS-3212SR Layer 3 Gigabit Switch
Parameters
[<portlist>| all ] {admin_state [enable | disable] |
max_learning_addr <max_lock_no 0-10> |
lock_address_mode [Permanent | DeleteOnTimeout |
DeleteOnReset]}
{ports <portlist>}
<vlan_name 32> mac_address <macaddr> port <port>
<portlist>
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to configure port security settings.
[<portlist> | all ] {admin_state [enable | disable] |
max_learning_addr <max_lock_no 0-10> |
lock_address_mode [Permanent | DeleteOnTimeout |
DeleteOnReset]}
This command allows for the configuration of the port security
feature. Only the ports listed in the <portlist> are effected.
<portlist> − Specifies a range of ports to be configured. The port
list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order.
all − Configure port security for all ports on the switch.
admin_state [enable | disable] – Enables or disables port security
for the listed ports.
max_learning_addr <max_lock_no 0-10> - Use this to limit the
P
S
ORT
ECURITY
29
6
C
OMMANDS

Advertisement

Table of Contents
loading

Table of Contents