Port Security Commands - D-Link DS-3550 Command Line Interface Reference Manual

The switch port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command
config port_security
ports
delete port_security
entry
clear
port_security_entry
show port_security
Each command is listed, in detail, in the following sections.
config port_security ports
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
Parameters
[<portlist>| all ] {admin_state [enable| disable]
|max_learning_addr <max_lock_no 0-10> | lock_address_mode
[Permanent | DeleteOnTimeout | DeleteOnReset]}
vlan_name <vlan_name 32> mac_address <macaddr> port <port>
port <portlist>
{ports <portlist>}
Used to configure port security settings.
config port_security ports [<portlist>| all ] {admin_state [enable|
disable] | max_learning_addr <max_lock_no 0-10> |
lock_address_mode [Permanent | DeleteOnTimeout |
DeleteOnReset]}
This command allows for the configuration of the port security feature.
Only the ports listed in the <portlist> are effected.
portlist − specifies a port or range of ports to be configured.
all − configure port security for all ports on the switch.
admin_state [enable|disable] – enable or disable port security for the listed
ports.
max_learning_addr <max_lock_no 0-10> - use this to limit the number of
MAC addresses dynamically listed in the FDB for the ports.
lock_address_mode[Permanent | DeleteOnTimout | DeleteOnReset] –
Indicates the method of locking addresses. The user has three choices:
Permanent – The locked addresses will not age out after the
aging timer expires.
DeleteOnTimeout – The locked addresses will age out after the
aging timer expires.
DeleteOnReset – The locked addresses will not age out until the
switch has been reset.
Only administrator-level users can issue this command.
P S
ORT ECURITY
24
6
C
OMMANDS