Port Security Commands - D-Link DGS-3100 SERIES Cli Manual

The Port Security commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command
config port_security
show port_security
Each command is listed in detail, as follows:
config port_security
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure port security:
Parameter
[<portlist> | all] {admin_state [enable | disable] | max_learning_addr <0-64> | trap
<1-1000000>}
{<portlist>}
To configure port security settings.
config port_security [<portlist> | all] {admin_state [enable |
disable] | max_learning_addr <int 0-64> | trap <interval 1-
1000000>}
The config port_security command configures port security
settings for specific ports.
portlist – A port or range of ports to be configured.
all – Configures port security for all ports on the Switch.
admin_state [enable | disable] – Enables or disables port security for
the listed ports.
max_learning_addr <int 0-64> -
0 means 'Classic Lock'
1-64 Limits the number of MAC addresses dynamically listed in the
FDB for the ports.
trap <interval 1-1000000> - Sends SNMP traps and defines the
minimum amount of time in seconds between consecutive traps.
Only administrator or operator-level users can issue this command
DGS3100# config port_security 1-5 admin_state enable
max_learning_addr 5
Success.
DGS3100#
DGS-3100 Series Gigabit Stackable Managed Switch CLI Manual

PORT SECURITY COMMANDS

20
118