Changing The Film View - AGFA Drystar 5302 Reference Manual

D 5302 R
RYSTAR EFERENCE MANUAL
Changing the input tray settings
In this manual, we always will elaborate a case for the lower tray. The procedures of
changing the settings are identical for the upper tray.
On the Change settings menu, press the Down key once to change the upper tray
settings, twice to change the lower tray settings.

Changing the film view

Using the following procedure you can change the film view.
Perform steps 1 and 2 of the
1
page 68.
On the Change settings menu, press the Down key once to change the upper
2
tray settings, twice to change the lower tray settings, followed by the Confirm
key'.
The 'Input tray' screen is displayed:
Press the Confirm key to select 'Film view'.
3
The 'Film view' screen is displayed:
1*Drystar DT 2B
2 Drystar DT 2C
The currently active film view is marked with a '*'.
Press the up/down arrow keys to select the film view.
4
Press the Confirm key to store the data, or the Escape key to quit the procedure
5
without any changes.
74
Advanced operation (Key-operator mode)
'Accessing the Change settings menu' procedure on
2830A EN 20050526