AGFA Drystar 5302 Reference Manual page 93

The Drystar 5302 will continue with the 'Select for Modality' screen, allowing
5
you to change the Look-up table, the Interpolation and the maximum density
(Dmax) values manually.
<Modality name>
3 Dmax
In the 'Select for Modality' screen, press the Confirm key to select 'Look-up
6
table'.
The 'Look-up table' screen is displayed:
<Modality name>
1*Linear
2 Kanamori
3 Kanamorilike (100)
Press the up/down key to select the desired look-up table.
7
Press the Confirm key to store the data, or the Escape key to quit the procedure
8
without any changes.
In case Kanamorilike (100) is selected, you can change the Kanamorilike value
(the range is: 75-220, the default value = 100).
An additional screen for the Kanamorilike value is displayed:
<Modality name>
Enter the Kanamorilike value by means of the arrow keys. Refer to
page 31. Press the Confirm key to store the data, or the Escape key to quit the
procedure without any changes.
2830A EN 20050526
Desired Kanamorilike value
Advanced operation (Key-operator mode)
D 5302 R
RYSTAR EFERENCE MANUAL
'Data entry' on
93