AGFA Drystar 5302 Reference Manual page 121

Clean the print head resistor line.
10
Gently pass over the resistor line a few times with a lint free cloth, slightly moistened
with Isopropyl alcohol or Ethanol. Do this only in one direction, i.e. from left to
right, without lifting the cloth.
Do not apply any pressure on the print head because this pressure may cause
damage on the interconnections underneath the print head.
Close the print head unit, the hold-down bracket and finally the top cover.
11
After you have cleaned the print head resistor line and you have closed the top cover,
you will return automatically to the Select calibration menu (see step 3).
If residue dust is present as part of the cleaning procedure it will disappear after a
few prints.
Press the Escape key to return to the key-operator main menu.
12
2830A EN 20050526
D 5302 R
RYSTAR EFERENCE MANUAL
Advanced operation (Key-operator mode)
121