AGFA Drystar 5302 Reference Manual page 50

D 5302 R
RYSTAR EFERENCE MANUAL
Checking the correct position of a film in the input tray
You can verify that the film is properly loaded by watching the lower right corner of
the films in the input tray. The rounding of this corner should be smaller than the
other three corners. This is also indicated on the sticker at the right side of the input
tray cover.
When the tray is closed, the Film Identification tag is read and the printer settings
are automatically adjusted if the film properties have changed. The Film
Identification tag is located on the protective sheet on the backside of the film pack.
The figure below shows the film pack upside down.
50
Basic operation (Operator mode) 2830A EN 20050526