D
5302 R
RYSTAR
EFERENCE MANUAL
Cleaning the print head
Print head cleaning must be done when image quality problems occur.
To clean the print head:
Press the Key-operator key to enter the key-operator mode.
1
On the key-operator main menu, press the Down key five times, followed by the
2
Confirm key to select 'Calibration'.
5 Restore config.
6 Calibration
7 Service Actions
8 Quality Control
9 Installation
On the Select calibration menu, press the Down key, followed by the Confirm
3
key to select 'Clean therm. head'.
The 'Thermal head cleaning' screen will give step-by-step instructions on what
4
to do:
118
Advanced operation (Key-operator mode)
2830A EN 20050526