Memory Switch Setting Mode - Epson TM-J9000 Technical Reference Manual

2.7.3 Memory Switch Setting Mode

The following items can be set in the memory switch setting mode:
❏ Conditions for BUSY (Msw1-3)
❏ Data processing for receiving errors (Msw1-4)
❏ Automatic line feed enabled/disabled (Msw1-5)
❏ Serial I/F pin # 6 or # 25 reset signal enabled/disabled (Msw1-7, 8)
❏ Serial transmission conditions (serial transmission conditions)
• Transmission speed
• Parity selection
• Handshaking
• Word length
Note:
Do not turn off the printer power while making settings in memory switch setting mode. Otherwise, new
settings will be cleared. After you complete steps in memory switch setting mode correctly, then turn off
the printer power.
2.7.3.1 Starting Memory Switch Setting Mode
Start memory switch setting mode by following the procedures below:
1. Open the roll paper cover.
2. Check that roll paper is inserted (insert roll paper regardless of whether roll paper is enabled
or disabled by Msw8-4).
3. With the roll paper cover open, press the FEED button and hold it while turning on the
power.
4. Check that the POWER, ERROR, and PAPER OUT LEDs are on; then press the FEED button
twice.
5. Close the roll paper cover. The printer prints items that can be set by the memory switches
and instructions.
6. Set switches by following the instructions.
2.7.3.2 Completing the Memory Switch Setting Mode
When the memory switch setting mode is completed, the settings are stored and the printer
starts initializing. When the initialization is completed, the printer is ready for printing.
2-16 Setup Rev. F