SETTINGS AND ADJUSTMENTS
Engine oil replacement and mesh filters-filter cartridge cleaning or replace-
ment
Drain the oil with WARM ENGINE; proceed as follows:
-
Remove the oil filler cap (2).
-
The oil sump guard (A) may be left in place. However, the procedure will be
easier with the guard removed.
-
Place an oil drain pan under the engine.
-
Remove oil drain plug (3) and filter (4), drain the oil and clean the plug mag-
net.
-
Wash the filter (4) with petrol and refit it into its seat.
-
Unscrew the screws (5) and remove cover (6) together with filter (7).
-
Change the filter (7) and refit the assembly making sure to fit the Belleville
washer (8) in the correct position.
-
Refit the drain plug (3) (25 Nm - 2.5 Kgm - 33.89 ft/lb) and the oil sump guard
(A).
-
Fill with the specified quantity of oil.
For recommended oil type and quantity, see "Capacities" table in Section
"A".
Be careful not to touch hot engine oil.
WARNING When assembling filter to cover, make sure to fit the filter
oil seal (A) first onto the cover (6).
A
6
D.16
7
8
H00977-1
Part. N. 8000 H1489 (10-2009)