Flywheel Installation (Tc); Assemble The Starter Motor (7) - Husqvarna TC 250 2010 Workshop Manual

ENGINE REASSEMBLY

Flywheel installation (TC)

Refit the rotor (5). Hold the rotor (5) to prevent rotation and place an aluminium
shim or dummy gear between the primary drives gears on the right side, again
to prevent rotation. Tighten the nut (6) to 75 Nm, 7.5 Kgm, 54.3 ft/lb. Use a 17
mm wrench.
Before installing the starter motor (7), check for free (clockwise) rotation of the
freewheel (4) while holding the rotor (5) steady.

Assemble the starter motor (7).

WARNING: On assembly, check the gasket (8) for damage and re-
place it if needed. Make sure to position it correctly with the gasket hole
(9) matching the hole (10) in the starter motor flange.
Fit the starter motor (7) into place.
Tighten the bevel drive screws (11) using a 4 mm Allen wrench (6 Nm - 0.6Kgm
- 4.43 ft/lb).
Tighten the screws (12) (12a) using a 4 mm Allen wrench (6 Nm - 0.6Kgm - 4.43
ft/lb).
12=L= 25 mm
12a=L=30 mm
H.42 Part. N. 8000 H1489 (10-2009)