Gear Position Sensor Inspection (Gps: Gear Position Sensor) - Husqvarna TC 250 2010 Workshop Manual

Gear position sensor inspection (GPS: Gear Position Sensor)

Set the meter to the "Ohm" scale and disconnect the six-way connector (1) of the
alternator from the main wiring harness (the gear sensor wiring is secured to the
alternator wiring with a clip). Touch one meter probe to engine ground and insert
the other probe into the connector hole for the WHITE/BLACK gear sensor wire
(2). The lever (3) is placed on the left-hand side of the engine. After each gear
shift, it automatically returns to the horizontal position. First gear is engaged by
pushing the lever downwards; for other gears push it upwards. Check the read-
ings provided in the relevant table.
TC
A NEUTRAL (open circuit)
B 1st
C 2nd
D 3rd
E 4th
F 5th
TE - TXC
A NEUTRAL
B 1st
C
2nd
D 3rd
E 4th
F 5th
G 6th
Part. N. 8000 H1489 (10-2009)
ELECTRICAL SYSTEM
556-568
817-833
1.48-1.51 K
2.71-2.77 K
6.75-6.88 K
312-319
725-739
1,31-1,34
2.18-2.23 K
3.61-3.68 K
6.58-6.71 K
15.2-15.5 K
M.27