Husqvarna TC 250 2010 Workshop Manual page 200

ENGINE REASSEMBLY
Refit the plates (6) (install a friction plate first and then a steel plate and keep
alternating between friction and steel plates; the last to go in should be a steel
plate). Fit actuator plate (7), thrust bearing (8), thrust washer (9), pressure plate
(10) and springs (11). Tighten the spring screws (12) gradually in a cross pattern
(5 Nm, 0.5 Kgm, 3.6 ft/lb).
Turn the engine over.
Install the clutch pushrod (13).
H.38 Part. N. 8000 H1489 (10-2009)