Engine Oil Replacement And Cartridge Filter Replacement; Coolant Level Check - Husqvarna NUDA 900 MY12 Operating & Maintenance Instructions

ENGINE OIL REPLACEMENT AND CARTRIDGE FILTER RE-
PLACEMENT
Note*:
We recommended having this done at an authorised
HUSQVARNA dealer.
WARNING*:
Be careful not to touch hot engine oil.
Drain the oil with WARM ENGINE; proceed as follows:
Place the motorcycle on the side stand;
-
Remove oil filler cap (1);
-
place a pan under the engine drainage plug;
-
remove oil drainage plug (2);
-
drain the exhausted oil, and clean magnet on plug
-
(2);
- using a suitable tool, unscrew the cartridge filter (3)
and remove it;
- replace the filter (3) with a new one and clean the
contact surfaces between the filter and the crankcase
before screwing it up, lubricate the seal with engine
oil and hand tighten it.
- screw the drainage plug (2) up again and replace the
seal;
- pour the recommended quantity of oil into the oil hole
(4);
- refit the oil drainage plug (1).
CAUTION*:
Switch on the engine for a short period
of time to allow the oil to reach all parts
of the engine and check the level as de-
scribed in the relevant section.
EN - 28 SPECIFICATIONS - OPERATION - MAINTENANCE
1
4
3
2

COOLANT LEVEL CHECK

When the engine is cold, check that the coolant level is
between the two MIN and MAX marks on the expan-
sion tank (1) on the right side of the vehicle.
1
If topping up is necessary, do the following:
- Remove the Allen wrench (2) provided on the right
hand side of the battery housing.
2