Rear Shock Absorber Removal - Husqvarna TC 250 2010 Workshop Manual

REAR SUSPENSION

Rear shock absorber removal

Set a block under the engine and see that the rear wheel is lifted from the
ground.
Remove saddle, side panels, silencer and rear chassis (see Section "E" - General
Procedures). Loosen the front clamp (1) of the intake coupling.
Remove the front bolt (2) securing the suspension linkage to the chassis, the
bottom (3) and top (4) shock absorber mounting bolts and remove the shock
absorber (5).
IMPORTANT: On assembly, fit the bottom locking nut (3) of the shock absorber
on the LEFT SIDE.
Part. N. 8000 H1489 (10-2009)
J.5