Crankshaft Assembly - Husqvarna TC 250 2010 Workshop Manual

ENGINE REASSEMBLY

Crankshaft assembly

Clean the oil galleries thoroughly. Lubricate the crank pin (1) with engine oil and
insert it into the flywheel half (2).
WARNING: Position the crank pin (1) so that hole "F" is lying on the
same axis as connecting rod (4) and flywheel half (2).
Fit the needle roller bearing (3) and lubricate it the engine oil. Install the connect-
ing rod (4) and the second flywheel half (5) and align the two flywheel halves
using a square.
H.16 Part. N. 8000 H1489 (10-2009)