Oil Level Check; Engine Oil Replacement And Cartridge Filter Replacement - Husqvarna TR 650 TERRA 2013 Workshop Manual

TR 650 TERRA 2013 - TR 650 STRADA 2013
MAX
MAX
MIN
MIN
3
2
3
SETTINGS AND ADJUSTMENTS

Oil level check

The oil level must be checked with the vehicle in vertical position on a flat sur-
face.
1
- Start the motorcycle and heat the engine until the cooling fan starts; wait for
another 3 minutes and switch off the engine.
- Check the level as follows:
- Undo the cap (1) with the dipstick (2) and remove it from the frame.
- Clean the dipstick (2) with a cloth.
- Place the dipstick (2) in the hole (3) without screwing the cap on.
- Remove the dipstick (2) from the hole (3) and check that the level is be-
tween the two MIN and MAX marks.
- To top up, pour oil into the hole (3); for the type of oil, see the section
"Technical data".
H11678

Engine oil replacement and cartridge filter replacement

1
Drain the oil with WARM ENGINE; proceed as follows:
- Place the motorcycle on its side stand
- Remove the cap (1) with the dipstick
Oil change must be performed in two stages:
Draining oil from tank;
Draining oil from engine
H11679
2
Draining oil from tank:
- Place a 2 litre container under the coupling (2) and then unscrew the screw
(3) and let the oil in the tank drain out completely.
- Once it has drained out, tighten the screw (3) with its corresponding washer.
Draining oil from engine:
- Place a container to collect the oil under the engine.
- Unscrew the screw (4) and let all the oil in the engine drain out completely.
- Once it has drained out, clean the magnetic screw (4), replace the gasket
and refit it on the engine by tightening it to torque.
Fill with oil as described in the relevant paragraph.
H11680
4
H11681
Never exceed max. level.
Be careful not to touch hot engine oil.
D.9
Workshop Manual Ed. 09-2012