Engine Oil Replacement And Mesh Filters-Filter Cartridge Cleaning Or Replacement - Husqvarna TE 250 - 310 2011 I.E. Workshop Manual

3a
3c
4
H02336
Ed. 07-2010
SETTINGS AND ADJUSTMENTS
Engine oil replacement and mesh filters-filter cartridge cleaning or replace-
ment
Drain the oil with WARM ENGINE; proceed as follows:
- Remove the oil filler cap (2).
- The oil sump guard (A) may be left in place. However, the procedure will be
easier with the guard removed.
- Place an oil drain pan under the engine.
(TE-TEi-TC-TXCi 250)
- Remove oil drain plug (3) and filter (4), drain the oil and clean the plug mag-
net.
- Wash the filter (4) with petrol and refit it into its seat.
250
(TE 310)
- loosen tie (3a) without disconnecting tube (3b);
- unscrew hose tail (3c), remove mesh filter (4) and drain the used oil.
- Unscrew the screws (5) and remove cover (6) together with filter (7).
- Change the filter (7) and refit the assembly making sure to fit the Belleville
washer (8) in the correct position.
(TE-TEi-TC-TXCi-250)
- Refit the drain plug (3) (25 Nm - 2.5 Kgm - 33.89 ft/lb) and the oil sump guard
(A).
(TE 310)
- Reassemble fitting (3c), screw clamp (3a), and refit the engine cover (A).
- Fill with the specified quantity of oil.
For recommended oil type and quantity, see "Capacities" table in Section
310
"A".
3b
Be careful not to touch hot engine oil.
H02335
WARNING When assembling filter to cover, make sure to fit the filter
oil seal (A) first onto the cover (6).
6
D.15
A
7
8
H00977-1