Silencer Sound Deadening Material Replacement - Husqvarna TC 250 2010 Workshop Manual

SETTINGS AND ADJUSTMENTS

Silencer sound deadening material replacement

Turn the rear fixing (1) counter clockwise and remove the saddle.
Loosen the screws (2) and remove the left-hand side panel (3).
Using an 8 mm T-wrench on the outside and a 10 mm T-wrench on the inside,
remove the silencer retaining screw (4). Remove the spring (5) and then the
screw (8) using an 8 mm T-wrench; remove the silencer. Remove the six rear
rivets (6), the clamp and the exhaust end cap (7).
Remove the inner pipe and replace the sound deadening material. Reassemble
the L.H. side panel and the saddle.
If the silencer proves hard to remove, tap lightly with a rubber or
plastic hammer to aid removal.
D.34 Part. N. 8000 H1489 (10-2009)