Husqvarna TC 250 2010 Workshop Manual page 262

FRONT SUSPENSION
Slide the damper rod (25) fully out (fully extended) again and top up oil up to
the edge.
Set the compression adjuster to 15 clicks from fully closed position.
Loosen the oil drain screw (1) in the compression valve unit (43).
Tighten the compression valve unit until you feel the outer O-ring starting to bind
inside the cap nut body.
Tighten the bleed screw to the specified torque using (see Tightening Torque
Figures table).
Remove the cartridge from the vice.
Clamp the cartridge (21) in the vice as shown in the diagram using the suitable
protector (R5155).
Screw the compression valve unit all the way home and tighten to the speci-
fied torque using a 21 mm open-end wrench (see Tightening Torque Figures
table).
Check for correct oil quantity.
Check as follows: pump the rod through several full strokes checking for smooth
motion. Also, the rubber bladder
should be swelling slightly when the cartridge is fully extended. If not so, add
a few cu cm of oil and repeat the bleeding procedure. It is easy to determine
whether there is not enough oil in the fork. With the cartridge fully extended, the
bladder collapses near the 4 radial oil passage holes of the cartridge.
I.42
Part. N. 8000 H1489 (10-2009)