Rear Shock Absorber Removal - Husqvarna TE 250 - 310 2011 I.E. Workshop Manual

REAR SUSPENSION

Rear shock absorber removal

Set a block under the engine and see that the rear wheel is lifted from the
ground.
Remove saddle, side panels, silencer and rear chassis (see Section "E" - General
Procedures). Loosen the front clamp (1) of the intake coupling.
1
H02293
Remove the front bolt (2) securing the suspension linkage to the chassis, the
bottom (3) and top (4) shock absorber mounting bolts and remove the shock
absorber (5).
IMPORTANT: On assembly, fit the bottom locking nut (3) of the shock absorber
on the LEFT SIDE.
Ed. 07-2010
J.5