Rear Shock Absorber Removal - Husqvarna WRE 125 2011 Workshop Manual

3
5
Ed. 05-2011
REAR SUSPENSION

Rear shock absorber removal

- Fit a support under the engine so that the rear wheel is raised off the
ground.
- Remove rear chassis, as described in paragraph E - General Procedures.
- Using a 14 mm wrench, loosen nut (1) on bike left side.
1
H02812
- Slightly raise rear swinging arm, and remove lower pin (2) from the right
side.
2
H02808
- Using a 14 mm wrench, loosen upper nut (3); then remove upper pin (4)
and shock absorber (5) from the left side.
4
On reassembly, position nut (3) and nut (1) on the left side of shock
absorber retaining pins.
H02811
J.5