Panasonic PanaVOICE system Technician Manual page 225

220 Appendix
PanaVOICE20
To use the USECPC Utility
1. Exit to DOS and go to the directory where the voice messaging software is installed
(usually this is C:\VMAIL).
2.
Type USECPC [Port] [Interrupt] [Repetitions], where [Port] is the number of the
voice messaging system port that the utility will use to run the test, [Interrupt] is
the voice board software interrupt, and [Repetitions] is the number of call repeti-
tions used for the test. For example, to run USECPC on port 1, with voice boards
that have an IRQ of 5, for 6 call repetitions, type USECPC 15 6 c-1.
3. Follow the on-screen instructions for running the Ring Test or the Busy Test. These
two tests set up the parameters the voice messaging system uses to detect a
ringback or busy tone.
If you are performing the Ring Test, do not pick up the test telephone' s receiver
during the test.
If
you are performing the Busy Test, be sure to take the test telephone off-hook
before starting the test.
4. After completing the test cycles, USECPC displays a summary of the signals it
aIXi.lyZd.
5. If you want to automatically update the voice messaging system with the param-
eters determined from the test, select Yes when you see the prompt: "Do you want
to update your AVSWlTCH.AVD right now?"
To use the GTDETECT Utility:
1.
2.
3.
4.
5.
Exit to DOS and go to the directory where the voice messaging software is installed
(usually this is C:\VMAIL).
Type GTDETECT c-1. After the computer reboots, a menu is displayed.
Select the tone you want the voice messaging system to learn. You can choose
SwitchReOrder, SwitchBusy, or SwitchDialtone.
You will be prompted to type the extension number of the tone source.
If
you are detecting SwitchReOrder tone, type an invalid extension number.
If you are detecting SwitchBusy tone, take the test telephone off-hook and then
type the extension of the test telephone.
If
you
are detecting SwitchDialtone, do not type an extension.
The test is complete when the monitor displays the menu again. After a successful
test, an option will be added to the menu that allows you to save the tone detec-
tion parameters to a file. If you want to automatically update the voice messaging
system with the parameters determined from the test, choose the option to save
the file.