Panasonic PanaVOICE system Technician Manual page 194

Technician k Guide
Appendix 189
Add voice
ports
If you are adding voice ports to your existing voice messaging system, and are using the
same type of voice board as used previously, follow the instructions below.
To add voice ports:
1.
2.
3.
4.
5.
Turn off the voice messaging computer.
Install the new voice board. Refer to the appropriate voice board note in this
appendix to complete this step.
Turn on the voice messaging computer.
Reprogram the system key. The reprogramming instructions are on the card
shipped with the new voice board.
Go to the directory where the voice messaging software is installed (usually
C:\VMAIL). Type
REiCONFIG[~)
and follow the on-screen prompts.