11.2
Installing processors
Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
V
CAUTION!
Processors are extremely sensitive to electrostatic discharge and must
be handled with care. After a processor has been removed from its
protective sleeve or from its socket, place it upside down on a
nonconducting, antistatic surface. Never push a processor over a
surface.
11.2.1 Preliminary steps
"Disabling or suspending BitLocker functionality" on page 77
Ê
"Disabling SVOM boot watchdog functionality" on page 78
Ê
"Shutting down the server" on page 48
Ê
"Disconnecting the server from the mains" on page 48
Ê
"Getting access to the component" on page 49
Ê
11.2.2 Installing a processor
I
This description applies to the following procedures:
– Installing the second processor in a single-processor configuration
– Transferring a processor after replacing the system board (see
section
TX2540 M1
"Replacing the system board" on page
Upgrade and Maintenance Manual
Hardware: 15 minutes
Software: 5 minutes
366)
Processors
275