Ricoh C2828 Function Manual page 507

For details about how to specify the path using Browse Network, see "Locating the NCP folder using
Browse Network".
18. Press [Connection Test] to check the path is set correctly.
19. Press [Exit].
20. Press [OK].
21. Press [Exit].
22. Press the [User Tools/Counter] key.
• To register the name, see "Registering Names".
• You can enter up to 128 characters for the user name.
• You can enter up to 64 characters for the password.
• To specify a folder, you can either enter the path manually or locate the folder by browsing the
network.
• If User Authentication is specified, contact your administrator.
• p.41 "File Transfer"
• p.245 "Registering Names"
Locating the NCP folder manually
This section describes how to locate the NCP folder manually.
1. Press [Change] under "Path".
2. Enter the path where the folder is located.
3. Press [OK].
4. Press [Connection Test] to check the path is set correctly.
5. Press [Exit].
• If you set "Connection Type" to [NDS], and if the NDS tree name is "tree", the name of the context
including the volume is "context", the volume name is "volume" and the folder name is "folder", then
the path will be "\\tree\volume. context\folder".
• If you set "Connection Type" to [Bindery], and if the NetWare server name is "server", the volume
name is "volume" and the folder name is "folder", then the path will be "\\server\volume\folder".
• You can enter a path using up to 256 characters.
• If the connection test fails, check the settings, and then try again.
Registering Folders
5
289