Ricoh C2828 Function Manual page 496

5. Registering Addresses and Users for Facsimile/Scanner Functions
For details about how to specify the path using Browse Network, see "Locating the SMB folder using
Browse Network".
17. Press [Connection Test] to check the path is set correctly.
18. Press [Exit].
If the connection test fails, check the settings, and then try again.
19. Press [OK].
20. Press [Exit].
21. Press the [User Tools/Counter] key.
• To register the name, see "Registering Names".
• You can enter up to 64 characters for the user name.
• You can enter up to 64 characters for the password.
5
• You can enter a path using up to 128 characters.
• If User Authentication is specified, contact your administrator.
• p.245 "Registering Names"
Locating the SMB folder manually
This section describes how to locate the SMB folder manually.
1. Press [Change] under "Path".
2. Enter the path where the folder is located.
3. Press [OK].
If the format of the entered path is not correct, a message appears. Press [Exit], and then enter the
path again.
• Enter the path using this format: "\\ServerName\Share- Name\PathName".
• You can also enter an IPv4 address.
• You can enter a path using up to 128 characters.
Locating the SMB folder using Browse Network
This section describes how to locate the SMB folder using Browse Network.
278