Ricoh C2828 Function Manual page 453

Message
pserver start. (NetWare)
Required file server (<file server name>) not found The required file server <file server name> could
sap enable. saptype=<SAP type>, sapname=<SAP
name>
server certificate invalid
server identity invalid
server not trusted
session IPv4 <community name> not defined.
session IPv6 <community name> not defined.
session IPX <community name> not defined.
Set context to <NDS contenxt name>
shutdown signal received. network service
rebooting...
Smbd start. (NetBIOS)
SMTPC: failed to get smtp server ip-address.
Problem and solutions
The NetWare service starts when the print server
goes online.
not be found.
The SAP function was been started. The SAP packet
is issued to advertise the service in the SAP table on
the NetWare server.
The server ID is disabled. Check the server
authentication.
The server ID is disabled. Check the server
authentication.
The RADIUS server cannot be trusted.
The requested community name is not defined.
The requested community name is not defined.
The requested community name is not defined.
The NDS context name <NDS context name> has
been set.
The smbd service has started.
SMBD (ServerMessageBlockDaemon) has been
started.
The SMTP server IP address could not be obtained.
This could be because:
• The specified DNS server could not be found.
• No connection to the network has been
established.
• The specified DNS server could not be found.
• An incorrect DNS server is specified.
• The specified SMTP server IP address could
not be found in the DNS server.
Message List
4
235