Ricoh C2828 Function Manual page 451

Message
(IKE phase-1) mismatched hash type: local=<Hash
Algorithm 1> remote=<Hash Algorithm 2>
Interface (interface name): Duplicate IP Address
(<IP address>).
<Interface name> card removed
<Interface name> interface down
<Interface name> interface up
< Interface > started with IP: < IP address >
< Interface >: Subnet overlap.
job canceled. jobid=%d.
LEAP challenge to access point failed
Login to fileserver <file server name> (<IPX|IP>),
<NDS|BINDERY>
Memory allocate error.
MIC failure TKIP counter measures started
Problem and solutions
group <DH group number 2>, Make sure this
machine's ISAKMP SA Oakley group matches that
of the communicating host.
This machine's ISAKMP SA <Hash Algorithm 1> in
IKE phase 1 does not match the communicating
host's ISAKMP SA <Hash Algorithm 2>, Make sure
this machine's ISAKMP SA Hash Algorithm matches
that of the communicating host.
The same IP (IPv4 or IPv6) address was used. Each
IP address must be unique. Check the address of
the device indicated in [IP address].
The interface managed by the supplicant has been
removed.
The interface managed by the supplicant is
disabled, or cannot connect to the access point.
The interface managed by the supplicant is
enabled, or is connected to the access point.
IP address (IPv4 or IPv6 address) has been set for
the interface and is operating.
The same IP address (IPv4, orIPv6 address) and the
subnet mask is used with other device.
The spooled job was canceled due to error or user
request.
The LEAP challenge to the access point has failed.
When the print server was online, the system
logged in to <file server> in NDS or BINDERY
mode. The transfer protocol in use is also displayed.
Date cannot be obtained. Disconnect the USB
cable, and then connect it.
The supplicant using TKIP has detected two
instances of tampering within 60 seconds and has
started counter measures.
Message List
4
233