Ricoh C2828 Function Manual page 776

7. Enhanced Network Security
Phase 2
Validity Period
Encryption Key Manual Settings Items
Address Type
7
Local Address
Remote Address
Encapsulation Mode
190
Setting
(auto setting)
Specify the time period for
which the SA settings in phase
2 are valid.
Setting
Specify the address type for
which IPsec transmission is
used.
Specify the machine's address.
If you are using multiple IPv6
addresses, you can also
specify an address range.
Specify the address of the IPsec
transmission partner. You can
also specify an address range.
Select the encapsulation mode.
Description
• 14
Specify a period (in seconds)
from 300 (5min.) to 172800
(48 hrs.).
Description
• Inactive
• IPv4
• IPv6
• IPv4/IPv6 (Default
The machine's IPv4 or IPv6
address.
If you are not setting an address
range, enter 32 after an IPv4
address, or enter 128 after an
IPv6 address.
The IPsec transmission partner's
IPv4 or IPv6 address.
If you are not setting an address
range, enter 32 after an IPv4
address, or enter 128 after an
IPv6 address.
• Transport
• Tunnel
(Tunnel beginning address -
Tunnel ending address)
If you select "Tunnel", set the
"Tunnel End Point", the
beginning and ending IP
addresses. In "Tunnel End
Point", set the same address for
Setting Value
Setting Value
Settings only)