Removing An E1 Digital Line Card; Configuring And Managing T1 Digital Line Cards - 3Com NBX 100 Administrator's Manual

240 C 3: D
HAPTER EVICE
Removing an E1
Digital Line Card
Configuring and
Managing T1
Digital Line Cards
C
ONFIGURATION
6 Click OK.
7 In the Digital Line Card IP Settings dialog box, click Apply.
8 Click OK.
You can remove a Digital Line Card at any time.
CAUTION: Removing a Digital Line Card may affect your Dial Plan.
To remove a Digital Line Card:
1 Select NBX NetSet > Device Configuration > Digital Line Cards.
2 From the Select Device Type drop-down list, select T1/ISDN Board List and
click Apply. A list of installed T1, ISDN PRI, and ISDN BRI boards appears in
the T1/ISDN Board List.
3 Select the board (Digital Line Card) you want to remove from the list.
4 Click Remove. A dialog box prompts you to confirm the removal.
5 Click Yes.
These sections describe how to add and configure a T1 Digital Line Card
(3C10116B and 3C10116C) to connect to a T1 service provided by the
local telephone company:
Adding a T1 Digital Line Card
■
Configuring a T1 Digital Line Card for the DS1 Protocol
■
Configuring a T1 Digital Line Card for ISDN PRI Signaling
■
T1 Card Status Lights
■
Modifying a T1 Card
■
Modifying a T1 Group
■
Modifying T1 Card Channels
■
Modifying IP Settings for a T1 Card
■
Removing a T1 Digital Line Card
■
In the NBX NetSet utility, Digital Line Cards are referred to as cards or
boards.
Some people refer to a T1 Digital Line Card by using the category name
TEP (T1, E1, ISDN PRI).