Configuring And Managing E1 Digital Line Cards - 3Com NBX 100 Administrator's Manual

226 C 3: D
HAPTER EVICE
Configuring and
Managing E1
Digital Line Cards
C
ONFIGURATION
To remove a Digital Line Card:
1 On the Digital Line Cards tab, from the Select Device Type drop-down list,
select T1/ISDN Board List and click Apply. A list of installed T1, ISDN PRI,
or ISDN BRI boards appears in the T1/ISDN Board List.
2 Select the board (Digital Line Card) you want to remove from the list.
3 Click Remove. A dialog box prompts you to confirm the removal.
4 Click Yes.
This section describes how to add and configure an E1 Digital Line Card
( ) to connect to an E1 service provided by the local telephone
3C10165C
company. In the NBX NetSet utility, Digital Line Cards are referred to as
either cards or boards.
This chapter covers these topics:
Adding an E1 Digital Line Card
■
Configuring the E1 Digital Line Card
■
E1 Card Status Lights
■
Modifying an E1 Card
■
Adding or Modifying an E1 Group
■
Modifying E1 Card Channels
■
Modifying IP Settings for an E1 Card
■
Removing an E1 Digital Line Card
■
You can configure an E1 Digital Line Card for ISDN PRI signaling only.