3Com NBX 100 Administrator's Manual page 175

Table 30 Feature Button Mappings (continued)
Function
Switch to DTMF
System
System Open, Closed,
Lunch, Other
Transfer
Xfer Vmail
Configuring the NBX 1105 Attendant Console
Description
Maps this button to the feature that switches this Analog
Line Card port from pulse dialing to tone dialing (DTMF).
Press this button once to switch to tone dialing. You
cannot switch from tone dialing back to pulse dialing
during a call. When you hang up the telephone, the Analog
Line Card port reverts to its default setting, either pulse
dialing or tone dialing, as configured by the system
administrator.
Number — Not used.
Prty (Priority) — Not used.
Intercom calls and outside calls from lines not mapped to
specific buttons ring on a System button. To call an outside
number from a System line, you must access a line pool by
dialing either 9 or 8, depending on your line pool
configuration.
By default, the bottom 3 buttons with lights have their
Type set to System.
Number — Not used.
Prty (Priority) — The button with the lowest value in the
Prty (Priority) field is the one that becomes active when you
lift the receiver or press the Speaker button.
Maps one of four system modes to this button. When the
button is pressed, it sets the Automated Attendant to play
the prompts appropriate to the selected mode (Open,
Closed, Lunch, or Other) when callers dial into the system.
Number — Not used.
Prty (Priority) — Not used.
Allows you to transfer a caller to an internal extension or an
external telephone number.
Number — Not used.
Prty (Priority) — Not used.
Allows you to transfer a caller directly to another person's
mailbox.
Number — Not used.
Prty (Priority) — Not used.
175