Rebooting A Line Card Port - 3Com NBX 100 Administrator's Manual

194 C 3: D
HAPTER EVICE
Rebooting a
Line Card Port
C
ONFIGURATION
Table 34 Device Status Dialog Box Fields (continued)
Field
Details of last 5 calls
To reboot a line card port:
1 Select NBX NetSet >
2 From the list, select the port that you want to reboot.
3 Click Status. The Device Status dialog box appears.
4 Click Reset Device.
5 Click .
OK
CAUTION: On the 3C10117 Analog Line Card, you can reboot individual
ports without affecting the other ports. However, if you reboot a port on
the 3C10117C Analog Line Card, all four ports on the card are rebooted.
Active telephone calls on any of these ports are disrupted.
Purpose
Information about the most recent five completed calls on a
port:
:
Call Direction Indicates whether the call originated
■
from inside the NBX system (outgoing call) or from
outside (incoming call). Values: Incoming, Outgoing.
:
Duration Length of the call in seconds.
■
:
Called Party The number or extension receiving the
■
call.
:
Calling Party The number or extension originating the
■
call.
:
Disconnect Indicates that a disconnect signal has been
■
received (the external party has hung up) or not
received. Values: Received, Not Received.
DTMF Digits: The digits that were dialed during the
■
call. This information appears only if the check box is
enabled.
Compression: Indicates the audio compression
■
technique used during the call. MULAW is used for
voice calls. ADPCM is used for voice mail.
Values: MULAW, ADPCM, ALAW, Linear.
Device Configuration
> Line Card Ports.