Modifying A Bri-St Card - 3Com NBX 100 Administrator's Manual

Modifying a These sections tell you how to modify a BRI card that is already installed in
BRI-ST Card the system:
Modifying a BRI Span
■
Modifying Audio Controls
■
For the BRI-ST card, you can modify only a BRI span. You cannot modify
the board type for a BRI-ST card.
Modifying a BRI Span
To modify a span:
1 On the Digital Line Cards tab, from the Select Device Type drop-down list,
select ISDN BRI Span List and then click Apply.
2 Select the span you want to modify from the Span List. Click Modify. The
Modify Span dialog box appears.
3 Make the changes that you want.
ISDN BRI-ST Digital Line Card supports two channels per span.
Table 43 Span Parameters
Parameter
Span Name
Interface Type
CO Switch Protocol
Framing Type
Line Code
Line Length
Timing Mode
Terminal Endpoint Identifier
(TEI)
4 Click Apply.
5 Enable the On Line check box to bring the span online. Note that the
span does not come online unless the card is online first.
6 Click Apply to make the changes and then click OK.
Configuring and Managing BRI-ST Digital Line Cards
Table 43
ISDN BRI Options
A name that helps you identify this span in span
lists.
N/A
ETSI
N/A
N/A
N/A
N/A
Enter the TEI number in the Manual TEI field or
select the Assign Automatic TEI check box. (When
this value is changed, the card reboots itself and all
current calls on the card are lost.)
lists all span parameters. The
219